Chrome
over Brass Ludwig Supersensitive or Ludalloy Shell?
The
question of whether or not a drum has a brass shell
is a very popular in the drumming community. This article
should help you get that answer.
Let's start by
saying most popular drum manufacturers prior to 1960
were using brass for their shells. I say "Most"
not all! I did have a 60's Sonor that was steel, a 60's
Ajax that was steel etc..
So is my drum
shell brass? Well, you can do some tests to make that
determination. Firstly and the most common method is
the Magnet Test.
To
do this correctly you will need a low grade magnet.
For me a skinny flat refrigerator magnet works best.
If it sticks or gives some noticeable resistance then
your drum is NOT brass, it is steel. You can do this
test on the hoops, lugs and strainer as well to see
if they are brass or steel.
If it does not
stick then it can be brass, aluminum, or some metal
combination that Ludwig used called Ludalloy.
Let's
discuss Ludwig a little bit since that is the most asked
question about the Ludwig Supraphonic and Supersensitive.
Is my Supra or Supra brass? Here is a little chart to
answer some general rules when looking at a supra or
super
Shell |
Brass
Shell |
Ludalloy |
Tone
Control |
Round
Knob (small) |
Baseball
Bat |
Badge |
Keystone
no serial number |
Keystone,
Blue Olive |
Snare
Beds |
Flange
Crimped Inward |
Crimped
different |
Chrome
|
No
pits at all |
Pits
on the shell |
I
know, I know, you have a (fill in the blank)
drum that is brass, but... We all know there are anomalies
and situations that do not apply to the general rules
of vintage drums! Let's get past that.
It
is also well documented that if you have a Supra with
a cut down Blue and Olive badge that the drum is more
then likely brass.
So I did mention other tests to definitively
make that determination, because there are 70's brass
Supras and the rumor is that they were special order
or endorser drums. They can also be chromed shells that
were ordered instead of the Black Beauty shell, which
was brass.
This test called the Cutting
Test will require a steady hand and a little
more work. You will need to take off the head and one
lug and look at the hole that the lug sits in. Now,
take a very sharp knife and or metal type cutting tool
and very, very carefully scrape the metal on the inside
of the hole. I say scrape, but more like take a fine
cutting sample. You will know right away if you see
brass.
I have never done this before and only
can mention what I have heard, so this would be a last
resort.
Another test is the Weight Test.
The brass shell Supras weigh more then the
Ludalloy version. How much I do not know for sure, but
I have seen and heard the brass drums are around 8-9
lbs or so and the Ludalloy versions are 5-6 lbs or so.
Other then that in some cases Ludwig
Stamped a " B" in some shells and a "
BR ", I have never seen the stamp and have heard
of it on the inside of the shell, by the strainer and
just recently someone emailed me because they had a
" B " stamped above the tone control.
So
with all of that said the reason the brass drums are
so popular and sought after is because they are worth
more money. Since the vintage drum market goes up and
down, I have seen some sell as low as $600 and at one
time they usually went for about $1000.
I
just want to finish with a re-iteration of the statement
that there are drum anomalies in the vintage community
that do not fit the criteria above that could be brass.
This is not an exact science!
The
" B " stamp behind the tone control |
|
|
|
|
|
Photo Courtesy:
Lenny Sanchez from Kyle Tx |
|
|
|